The Alfa Laval i-CP2000 pump is a highly efficient and economical centrifugal pump, which meets the requirements of sanitary and gentle product treatment and chemical resistance.
The pump is available in six sizes, Alfa Laval i-CP2010, -20, -25, -35, -40,-50.
The Alfa Laval i-CP2000 pump consists of a standard motor, stub shaft, mechanical compression coupling, adaptor, back plate, impeller, casing pump and shaft seal. The pump is designed
for CIP with emphasis on large internal radii and easy cleanable seals. The pump has a stainless steel shroud for protection of the motor, and the complete unit is supported on four adjustable legs.
The Alfa Laval i-CP2000 pump is equipped with an external single or double mechanical shaft seal. All have stationary seal rings in acid resistant steel AISI 316L with sealing surfaces in silicon carbide and rotating seal rings in carbon (optional silicon carbide). Double mechanical seal is equipped with a secondary mechanical seal.
-Product wetted steel parts: 1.4404 (316L)
-Other steel parts: Stainless steel 304, surface treated carbon steel.
-Inside surface finish: Semi bright.
-Product wetted elastomers: EPDM (FDA)
-Air evacuation: 2800-3600 rpm
-Pumping product (no air): 900-3600 rpm
Motor
Foot-flanged motor according to the IEC metric standard, 2 poles = 3000/3600 rpm at 50/60 Hz, IP 55 (with drain hole with labyrinth plug), insulation class F.
Water pressure inlet: . . . . . . . . . . . . Max. 500 kPa (5 bar).
Water consumption: . . . . . . . . . . . . 0.25 -0.5 l/min.
Temperature range . . . . . . . . . . . . . 0°C to +140°C
The Alfa Laval i-CP2000 pump is designed, tested and approved according to EHEDG guidelines